I was getting bored of connecting the PODs of my HP 16500B/16550 Logic Analyzer to the Transwarp GS diagnostics header. So I set to create a small board, from which I connect the PODs from the Logic Analyzer and a ribbon cable to the 40 pin header on the Transwarp GS.
I’ll post the files (schematics/board design) later on, as there seems to be an issue with the footprint of the resistor arrays I wanted to use. Right now I ‘solved’ it by soldering 0603 resistors, bridging a little gap over the solder mask (not beautiful, but it works)